Simple Top Using Simplicity Pattern #7182
 |
| There are only two patterns pieces. There are no bindings or facings.
The neckline, armholes, and hem are all turned up and hemmed. I used my
serger to finish the rough edges before hemming. |
 |
| The front and back are both cut on the fold. The knit I am using is
60" wide so I refolded it with the selvage in the center leaving two
folded edges for each pattern piece |
 |
| This design has very wide shoulder seams. To keep it from stretching
later and breaking the stitches I used narrow strips of the knit cut on
the lengthwise grain (least stretchy) in place of stay tape. |
 |
| Before making the first stitch on the garment, I stitched a test piece to
check the stitches to be sure they would not pop when stretched and that
there are no needle cuts. |
 |
| If you pull the seam open and see tiny cuts in the fabric you need to
change your needle. Use a needle designed for knits in a size
appropriate for your project. |
 |
| OK - it's all sewn together - two side seams, two shoulder seams (with stay strips), and serged around the edges that will be hemmed. The neckline and armnole edges were turned under 1/2" and stitched down using a long stretch stitch, the bottom was turned up a little more to make a wider hem. If you haven't worked with knits much you might be tempted to throw in the towel at this point because it's likely the neckline will not look nice at all. Don't worry about the appearance at this point - a little steam and pressure will work magic. |
 |
| I like using a medium length stretch stitch to hem knits when the stitching will be visible. Sometimes I will widen the stitch width to just barely enough to be noticeable to provide an extra measure of protection against popped stitches - you never know when a child will tug on your shirttail... |
 |
Cap sleeve edge was turned up to form a half inch hem |
 |
Press the hems.
Use the curves and surfaces of an ironing board for what they were designed for - pin block to the ironing board. Use a pressing cloth and a lot of steam, applying downward pressure, press the hems. |
 |
| The finished neckline, after pressing is smooth and flat. I pinned it to the ironing board cover as I pressed it and allowed it to cool. Kind of like blocking a knit project. |
 |
| Bottom hem is smooth and flat. |
 |
| Finish up by pressing the side seams and shoulder seams |
 |
| I probably should have stopped after pressing the side and shoulder seams but decided to go back and add a second row of topstitching to the hemmed edges |
 |
Finished bottom hem. This is when I discovered that my top and bottom thread on my sewing machine were different shades of red. The first row of topstitching was done from the wrong side, and the top row from the right side.
|
